DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
DES-3026:4# config 802.1p user_priority 1 3
Command: config 802.1p user_priority 1 3
Success.
DES-3026:4#
show 802.1p user_priority
Purpose Used to display the current mapping between an incoming packet’s
802.1p priority value and one of the Switch’s four hardware priority
classes of service.
Syntax
show 802.1p user_priority
Description
The show 802.1p user_priority command displays the current
mapping of an incoming packet’s 802.1p priority value to one of the
Switch’s four hardware priority classes of service.
Parameters None.
Restrictions None.
Example usage:
To show 802.1p user priority:
DES-3026:4# show 802.1p user_priority
Command: show 802.1p user_priority
QOS Class of Traffic
Priority-0 -> <Class-0>
Priority-1 -> <Class-0>
Priority-2 -> <Class-1>
Priority-3 -> <Class-1>
Priority-4 -> <Class-2>
Priority-5 -> <Class-2>
Priority-6 -> <Class-3>
Priority-7 -> <Class-3>
DES-3026:4#
config 802.1p default_priority
Purpose Used to assign an 802.1p priority tag to an incoming untagged
packet that has no 802.1p priority tag.
Syntax
config 802.1p default_priority [<portlist> | all] <priority 0-7>
Description
The config 802.1p default_priority command allows you to specify
the 802.1p priority value an untagged, incoming packet will be
assigned before being forwarded to its destination.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
all − Specifies that the config 802.1p default_priority command
will be applied to all ports on the Switch.
<priority 0-7> − Specifies the 802.1p priority value that an untagged,
incoming packet will be given before being forwarded to its
destination.
79
To Next Page
Loading...
