D-Link DES-3010G - Config Snmp Engineid; Show Snmp Engineid

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
Example usage:
To display the currently entered SNMP community strings:
DES-3026:4#show snmp community
Command: show snmp community
SNMP Community Table
Community Name View Name Access Right
-------------------------------- -------------------------- ------------
dlink ReadView read_write
private CommunityView read_write
public CommunityView read_only
Total Entries: 3
DES-3026:4#
config snmp engineID
Purpose Used to configure a name for the SNMP engine on the Switch.
Syntax
config snmp engineID <snmp_engineID>
Description
The config snmp engineID command configures a name for the
SNMP engine on the Switch.
Parameters
<snmp_engineID> − An alphanumeric string that will be used to
identify the SNMP engine on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To give the SNMP agent on the Switch the name “0035636666”
DES-3026:4#config snmp engineID 0035636666
Command: config snmp engineID 0035636666
Success.
DES-3026:4#
show snmp engineID
Purpose Used to display the identification of the SNMP engine on the Switch.
Syntax
show snmp engineID
Description
The show snmp engineID command displays the identification of
the SNMP engine on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the current name of the SNMP engine on the Switch:
34