D-Link DES-3010G - Layer 2 (L2) Features; VLANs Configuration

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
show bandwidth_control
Syntax
show bandwidth_control {<portlist>}
Description
The show bandwidth_control command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
Parameters
<portlist> − Specifies a port or range of ports to be viewed.
Using this command without adding a portlist entry will show the
bandwidth control for all ports in the Switch stack.
Restrictions None.
Example usage:
To display bandwidth control settings:
DES-3026:4#show bandwidth_control 1-12
Command: show bandwidth_control 1-12
Bandwidth Control Table
Port RX Rate (kbit/sec) TX_RATE (kbit/sec)
---- ------------------------ ----------------------
1 100000 100000
2 100000 100000
3 100000 100000
4 100000 100000
5 100000 100000
6 100000 100000
7 100000 100000
8 100000 100000
9 100000 100000
10 100000 100000
11 no_limit no_limit
12 no_limit no_limit
DES-3026:4#
83