DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
config scheduling
Parameters
<class_id> − Specifies which of the four priority classes of service to
which the config scheduling command will be applied. The four
priority classes of service are identified by number − from 0 to 3 −
with class 3 being the highest priority.
weight <value 1-55> − Specifies the maximum number of packets
the above specified priority class of service will be allowed to
transmit before allowing the next lowest priority classes of service to
transmit its packets. A value between 1 and 55 packets can be
specified. The default value is per class is:
Class Weight
0 1
1 2
2 4
3 8
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure traffic scheduling:
DES-3026:4# config scheduling 3 weight 15
Command: config scheduling 3 weight 15
Success.
DES-3026:4#
show scheduling
Purpose Used to display the currently configured traffic scheduling on the
Switch.
Syntax
show scheduling
Description
The show scheduling command displays the current configuration
for the maximum number of packets (weight) value assigned to the
four priority classes of service on the Switch. The Switch will empty
the four hardware classes of service in order, from the highest
priority (class 3) to the lowest priority (class 0).
Parameters None.
Restrictions None.
Example usage:
To display the current scheduling configuration:
77
To Next Page
Loading...
