DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
To configure 802.1x authentication parameters for ports 1 – 20:
DES-3026:4#config 802.1x auth_parameter ports 1 – 20 direction both
Command: config 802.1x auth_parameter ports 1 – 20 direction both
Success.
DES-3026:4#
config 802.1x auth_protocol
Purpose Used to configure the 802.1x authentication protocol on the
Switch.
Syntax
config 802.1x auth_protocol [local | radius_eap]
Description
The config 802.1x auth_protocol command enables you to
configure the authentication protocol.
Parameters [local | radius_eap] – Specify the type of authentication protocol
desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the authentication protocol on the Switch:
DES-3026:4# config 802.1x auth_protocol local
Command: config 802.1x auth_protocol local
Success.
DES-3026:4#
config 802.1x init
Purpose Used to initialize the 802.1x function on a range of ports.
Syntax
config 802.1x init [port_based ports [<portlist> | all] | mac_based ports
[<portlist> | all] {mac_address <macaddr>}]
Description
The config 802.1x init command is used to immediately initialize the 802.1x
functions on a specified range of ports or for specified MAC addresses operating
from a specified range of ports.
Parameters port_based ports – This instructs the Switch to initialize 802.1x functions based
only on the port number. Ports approved for initialization can then be specified.
<portlist> − Specifies a port or range of ports to be initialized.
all − Specifies all of the ports on the Switch to be initialized.
mac_based - This instructs the Switch to initialize 802.1x functions based on the
MAC address of a device on a specific port or range of ports. MAC address
approved for initialization can then be specified.
ports <portlist> − Specifies a port or range of ports.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Specifies the MAC address of the client to be added.
Restrictions Only administrator-level users can issue this command.
115
To Next Page
Loading...
