D-Link DES-3010G - Save; To Disable HTTP

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
enable web
are numbered between 1 and 65535. The “well-known” port for the
Web-based management software is 80.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable HTTP and configure port number:
DES-3026:4#enable web 80
Command: enable web 80
Success.
DES-3026:4#
disable web
Purpose Used to disable the HTTP-based management software on the
Switch.
Syntax
disable web
Description This command disables the Web-based management software on
the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable HTTP:
DES-3026:4#disable web
Command: disable web
Success.
DES-3026:4#
save
Purpose Used to save changes in the Switch’s configuration to non-volatile
RAM.
Syntax
save
Description This command is used to enter the current switch configuration into
non-volatile RAM. The saved switch configuration will be loaded into
the Switch’s memory each time the Switch is restarted.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
19