DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
DES-3026:4#disable syslog
Command: disable syslog
Success.
DES-3026:4#
show syslog
Purpose Used to display the syslog protocol status as enabled or disabled.
Syntax
show syslog
Description
The show syslog command displays the syslog status as enabled
or disabled.
Parameters None.
Restrictions None.
Example usage:
To display the current status of the syslog function:
DES-3026:4#show syslog
Command: show syslog
Syslog Global State: Enabled
DES-3026:4#
create syslog host
Purpose Used to create a new syslog host.
Syntax
create syslog host <index 1-4> {severity [informational |
warning | all] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port <int> | ipaddress <ipaddr>
state [enable | disable]}
Description
The create syslog host command is used to create a new syslog
host.
Parameters
<index 1-4> − Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
severity − Severity level indicator. These are described in the
following:
Bold font indicates that the corresponding severity level is currently
supported on the Switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
54
To Next Page
Loading...
