xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Section 4
L3 Features
Interface Settings
MD5 Key Settings
Route Redistribution Settings
Multicast Static Route Settings
Static/Default Route Settings
Route Preference Settings
Static ARP Settings
Gratuitous ARP Settings
Policy Route Settings
ECMP Algorithm Settings
IP Tunnel Settings
RIP
OSPF
DHCP Server
DHCPv6 Server
Filter DHCP Server
DNS Relay
DNS Resolver
VRRP
IP Multicast Routing Protocol
BGP
IP Route Filter
The following section will aid the user in configuring security functions for the Switch.
The Switch has the capability to support the following:
• IPv6 unicast, multicast and anycast addresses
• Allow for IPv6 packet forwarding
• IPv6 fragmentation and re-assembly
• Processing of IPv6 packet and extension headers
• Static IPv6 route configuration
• IPv6 Neighbor Discovery
• Link-Layer Address resolution, Neighbor Unreachability Detection and Duplicate Address Detection over broadcast
mediums (ex: Ethernet)
• Send Router Advertisement
• ICMPv6 functionality
The following sections will briefly explain IPv6, its functionality and how IPv6 is implemented on this Switch.
Overview
IP version 6 is the logical successor to IP version 4. It was known that IPv4 could not support the amount of addresses that would
eventually be needed for not only each person, but each device that would require an IP address, and therefore a system with a
167
To Next Page
Loading...
Need help?
General