xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
RIPng
The Switch supports Routing Information Protocol next generation (RIPng). RIPng is a routing protocol that exchanges routing
information used to compute routes and is intended for IPv6-based networks.
RIPng Global Settings
This window allows users to set up RIPng.
To globally enable RIPng on the Switch, click L3 Features > RIP > RIPng > RIPng Global Settings, as shown below:
Figure 4- 33. RIPng Global Settings window
The following settings can be configured:
Parameter Description
Global State
Enable or disable RIPng globally. The default setting is Disabled.
Method
Choose from No Horizon, Split Horizon, and Poison Reverse. No Horizon – Configured to
not use any horizon. Split Horizon – Configured to use basic split horizon. This is the
default setting. Poison Reverse – Configured to use split horizon with poison reverse.
Update Time (5-65535)
Enter the value (in seconds) of the update timer.
Expire Time (1-65535)
Enter the interval (in seconds) of the expire timer.
Garbage Collection
Time (1-65535)
Enter the value (in seconds) of the garbage collection timer.
Click Apply to implement changes made.
197
To Next Page
Loading...
