xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
DHCPv6 Server Manual Binding Settings
This window is used to configure DHCPv6 server manual binding settings. An address binding is a mapping between the IPv6
address and DUID (A DHCPv6 Unique Identifier for a DHCPv6 participant) of a client. The IPv6 address specified in the manual
binding entry must be in the range of the DHCPv6 pool. If the user specifies a conflict IPv6 address, an error message will be
returned.
To view this window, click L3 Features > DHCPv6 Server > DHCPv6 Server Manual Binding Settings, as shown below:
Figure 4- 87. DHCPv6 Server Manual Binding Brief Table window
The following parameter may be configured:
Parameter Description
Pool Name
Enter the pool name.
Clicking the View button will reveal the following window to configure:
Figure 4- 88. DHCPv6 Server Manual Binding Settings - Add window
The following parameter may be configured:
Parameter Description
Pool Name
Enter the name of the previously created pool that will contain the manual binding entry.
IPv6 Address
Enter the IPv6 address to be statically bound to a device.
Client DUID
Enter the DHCPv6 Unique Identifie (DUID) of the device to be statically bound to the IPv6
address entered in the previous field. The DUID string must be '0--9', 'a--f' or ' A--F'.
Click Apply to implement changes made. To remove an entry from the table, click its corresponding under the Delete heading.
242
To Next Page
Loading...
