xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 7- 38. Web-based Access Control Authentication Login window
After successfully logging in, the user will be prompted with this window, verifying that the user has successfully authenticated
the WAC port.
Figure 7- 39. WAC Logout window
NOTE: The previous logout screen may have some problems when using Netscape 7.0.
If the port where Web-Access Control is preset to be moved to a VLAN without an IPIF
interface, the previous logout screen may also not be presented when logging in.
WAC Authentication State
This window is used to enable and configure Web-based Access Control Host Table Settings on the Switch.
To view this window, click Security > Web-based Access Control (WAC) > WAC Authentication State, as shown below:
Figure 7- 40. WAC Authentication State window
The following parameters can be configured:
375
To Next Page
Loading...
