xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
DHCP/BOOTP Local Relay Settings
This window is used to configure the global settings of DHCP/BOOTP local relay.
To view this window, click Administration > DHCP/BOOTP Local Relay Settings, as shown below:
Figure 2- 56. DHCP/BOOTP Local Relay Global Settings window
The following parameters are displayed or can be configured:
Parameter Description
Global State
Use the pull-down menu to enable or disable the status.
VLAN State
Use the pull-down menu to enable or disable the VLAN status.
VLAN Name
Enter the name of VLAN.
VID List
Display the VLAN list.
Click Apply to implement the changes.
DHCPv6 Relay
This section contains information for configuring DHCPv6 relay, including DHCP v6 Relay Global Settings and DHCPv6 Relay
Interface Settings.
DHCPv6 Relay Global Settings
This window is used to set up the DHCPv6 relay global status.
To view this window, click Administration > DHCPv6 Relay > DHCPv6 Relay Global Settings, as shown below:
Figure 2- 57. DHCPv6 Relay Global Settings window
The following fields can be configured:
Parameter Description
Global State
This field can be toggled between Enabled and Disabled using the pull-down menu. It is
used to enable or disable the DHCPv6 Relay service on the Switch. The default is
Disabled.
55
To Next Page
Loading...
Need help?
General