xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
0x0-0xffff) which you wish to filter.
Select UDP to use the IPv6 UDP port number contained in an incoming packet as the
forwarding criterion. Selecting IPv6 UDP requires that you specify a source port mask and/or a
destination port mask.
src port mask - Specify a IPv6 UDP port mask for the source port in hex form (hex 0x0-
0xffff).
dst port mask - Specify a IPv6 UDP port mask for the destination port in hex form (hex 0x0-
0xffff)
Click Apply to implement changes made.
To view the configurations set for a previously created access profile, return to the Access Profile Table and click the
button
under the Display heading, corresponding to the access profile for which to view configurations. A window similar to the one
below will be displayed.
Figure 6- 7. Access Profile Entry Display window (Ethernet)
To establish the rule for a previously created Access Profile:
To view this window, click ACL > Access Profile Table, as shown below:
Figure 6- 8. Access Profile Table window
To create a new rule set for an access profile click the Modify button located under the Access Rule heading. The window shown
below (Access Profile Rule) will be displayed. To remove a previously created rule, click the corresponding
button.
312
To Next Page
Loading...
