xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 6- 17. Access Rule Display window (Packet Content Mask)
NOTE: When using the ACL Mirror function, ensure that the Port Mirroring
function is enabled and a target mirror port is set.
To configure the Access Rule for IPv6, open the Access Profile Table window and click Modify for an IPv6 entry. This will open
the following window:
Figure 6- 18. Access Rule Table window (IPv6)
To remove a previously created rule, click its corresponding
button. To add a new Access Rule, click the Add Rule button:
321
To Next Page
Loading...
