xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Address
the IP address mask, in hex form.
Click Apply to implement changes made.
To establish the rule for a previously created CPU Access Profile:
To view this window, click ACL > CPU Interface Filtering > CPU Interface Filtering Table, as shown below:
Figure 6- 30. CPU Interface Filtering Table window - Add
In this window, the user may add a rule to a previously created CPU access profile by clicking the corresponding Add Rule
button of the entry to configure Ethernet, IPv4, Packet Content Mask, or IPv6.
Figure 6- 31. CPU Interface Filtering Rule Table window
Click the Add Rule button to continue on to the CPU Interface Filtering Rule Table window. A new and unique window, for
Ethernet, IP, Packet Content and IPv6 will open as shown in the examples below.
To change a rule for a previously created CPU Access Profile Rule:
The CPU Interface Filtering Rule Configuration window allows the user to create a rule for a previously created CPU Access
Profile.
333
To Next Page
Loading...
