xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
487
3. In the “Password Recovery Mode” only the following commands can be used.
Command Parameters
reset config
This command resets the whole configuration back to the default
values.
reboot
This command exits the Reset Password Recovery Mode and
restarts the switch. A confirmation message will be displayed to allow
the user to save the current settings.
reboot force_agree
This command forces the switch to restart.
reset account
This command deletes all the previously created accounts.
reset password
{<username>}
This command resets the password of the specified user. If a
username is not specified, the password of all users will be reset.
show account
This command displays all previously created accounts.
To Next Page
Loading...
