DIR-816L Wireless AC750 Dual Band Router & Access Point
with 3G/CDMA/LTE Support and USB Port
User Manual
Configuring Device (Router Mode)
You can specify the following parameters:
Parameter Description
Open access from any
external host
Select the checkbox to allow access to the router for any host. When
the checkbox is selected, the IP version drop-down list is
displayed on the page, and the IP address and Mask fields are not
available for editing.
IP version
An IP version to which the rule will be applied. Select the relevant
value from the drop-down list.
IP address
A host or a subnet to which the rule is applied. You can specify an
IPv4 or IPv6 address.
Mask
For the IPv4-based network only.
The mask of the subnet.
Public port
For the IPv4-based network only.
An external port of the router. You can specify only one port.
Protocol The protocol available for remote management of the router.
After specifying the needed parameters, click the Apply button.
To edit a rule for remote access, click the link to the relevant rule. On the opened page, change the
needed parameters and click the Apply button.
To remove a rule for remote access, select the checkbox located to the left of the relevant line in the
table and click the Delete button. Also you can remove a rule on the editing page.
Page 178 of 304
To Next Page
Loading...
