D-Link X-STACK DES-3200 SERIES - Page 128

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
124
10-16 enable ipif
Description
This commands is used to enable the IP interface.
Format
enable ipif [<ipif_name 12> | all]
Parameters
ipif_name - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all – Specify that all the IP interfaces will be enabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable an IP interface:
DES-3200-28P:admin#enable ipif newone
Command: enable ipif newone
Success.
DES-3200-28P:admin#
10-17 disable ipif
Description
This command is used to disable an IP interface.
Format
disable ipif [<ipif_name 12> | all]
Parameters
ipif_name - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all – Specify that all the IP interfaces will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.