D-Link X-STACK DES-3200 SERIES - Chapter 66 System Log Command List

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
571
Chapter 66 System Log Command List
clear log
show log {[index <value_list> | severity {module <module_list>} {emergency | alert | critical | error |
warning | notice | informational | debug | <level_list 0-7>} | module<module_list>]}
show log_software_module
enable syslog
disable syslog
show syslog
create syslog host <index 1-4> ipaddress <ipaddr> {severity [emergency | alert | critical | error |
warning | notice | informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 |
local4 | local5 | local6 | local7] | udp_port <udp_port_number> | state [enable | disable]}
config syslog host [<index> | all] {severity [emergency | alert | critical | error | warning | notice |
informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 | local5 |
local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable | disable]}
delete syslog host [<index 1-4> | all]
show syslog host {<index 1-4>}
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
show log_save_timing
show attack_log {index <value_list>}
clear attack_log
66-1 clear log
Description
This command is used to clear the Switch’s history log.
Format
clear log
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To clear the Switch’s history log:
DES-3200-28P:admin#clear log
Command: clear log
Success.
DES-3200-28P:admin#