D-Link X-STACK DES-3200 SERIES - Show Lldp

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
352
DES-3200-28P:admin#config lldp ports all dot1_tlv_protocol_identity all enable
Command: config lldp ports all dot1_tlv_protocol_identity all enable
Success.
DES-3200-28P:admin#
To configure exclude the MAC/PHY configuration/status TLV from the outbound LLDP
advertisements for all ports:
DES-3200-28P:admin#config lldp ports all dot3_tlvs mac_phy_configuration_status
enable
Command: config lldp ports all dot3_tlvs mac_phy_configuration_status enable
Success.
DES-3200-28P:admin#
37-6 config lldp forward_ message
Description
This command is used to configure forwarding of LLDP PDU packet when LLDP is disabled.
Format
config lldp forward_message [enable | disable]
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure LLDP to forward LLDP PDUs:
DES-3200-28P:admin#config lldp forward_message enable
Command: config lldp forward_message enable
Success.
DES-3200-28P:admin#
37-7 show lldp
Description
This command is used to display the Switch’s general LLDP configuration status.