D-Link X-STACK DES-3200 SERIES - Page 357

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
353
Format
show lldp
Parameters
None.
Restrictions
None.
Example
To display the LLDP system level configuration status:
DES-3200-28P:admin#show lldp
Command: show lldp
LLDP System Information
Chassis ID Subtype : MAC Address
Chassis ID : 00-01-02-03-04-00
System Name :
System Description : Fast Ethernet Switch
System Capabilities : Repeater, Bridge
LLDP Configurations
LLDP Status : Enabled
LLDP Forward Status : Enabled
Message TX Interval : 30
Message TX Hold Multiplier: 4
ReInit Delay : 2
TX Delay : 2
Notification Interval : 10
DES-3200-28P:admin#
37-8 show lldp mgt_addr
Description
This command is used to display the LLDP management address information.
Format
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
Parameters
ipv4 - (Optional) Specify the IPv4 address used for the display.
<ipaddr> - Enter the IPv4 address used for this configuration here.