D-Link X-STACK DES-3200 SERIES - Show Gvrp

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
33
Format
config gvrp [timer {join < value 100-100000> | leave < value 100-100000> | leaveall <value
100-100000>} | nni_bpdu_addr [dot1d | dot1ad]]
Parameters
timer - Specify that the GVRP timer parameter will be configured.
join - (Optional) Specify the Join time will be set.
<value 100-100000> - Enter the time used here. This value must be between 100 and
100000.
leave - (Optional) Specify the Leave time will be set.
<value 100-100000> - Enter the time used here. This value must be between 100 and
100000.
leaveall - (Optional) Specify the LeaveAll time will be set.
<value 100-100000> - Enter the time used here. This value must be between 100 and
100000.
nni_bpdu_addr - Used to determine the BPDU protocol address for GVRP in service provide
site. It can use 802.1d GVRP address, 802.1ad service provider GVRP address or a user
defined multicast address. The range of the user defined address is 0180C2000000 -
0180C2FFFFFF.
dot1d - Specify that the NNI BPDU protocol address value will be set to Dot1d.
dot1ad - Specify that the NNI BPDU protocol address value will be set to Dot1ad.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the Join time to 200 milliseconds:
DES-3200-28P:admin#config gvrp timer join 200
Command: config gvrp timer join 200
Success.
DES-3200-28P:admin#
3-16 show gvrp
Description
This command is used to display the GVRP global setting.
Format
show gvrp
Parameters
None.