D-Link X-STACK DES-3200 SERIES - Delete Mac_Based_Access_Control

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
380
Example
To create a MAC-based Access Control guest VLAN:
DES-3200-28P:admin#create mac_based_access_control guest_vlan VLAN8
Command: create mac_based_access_control guest_vlan VLAN8
Success.
DES-3200-28P:admin#
40-8 delete mac_based_access_control
Description
This command is used to remove a MAC-based Access Control guest VLAN.
Format
delete mac_based_access_control [guest_vlan <vlan_name 32> | guest_vlanid <vlanid 1-
4094>]
Parameters
guest_vlan - Specify the name of the MAC-based Access Control’s guest VLAN.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
guest_vlanid - Specify the VID of the MAC-based Access Control’s guest VLAN.
<vlanid 1-4094> - Enter the VLAN ID here. This value must be between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete the MAC-based Access Control guest VLAN called default:
DES-3200-28P:admin#delete mac_based_access_control guest_vlan default
Command: delete mac_based_access_control guest_vlan default
Success.
DES-3200-28P:admin#
40-9 clear mac_based_access_control auth_state
Description
This command is used to clear the authentication state of a user (or port). The port (or the user)
will return to an un-authenticated state. All the timers associated with the port (or the user) will be
reset.