D-Link X-STACK DES-3200 SERIES - Show Snmp Host

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
544
DES-3200-28P:admin#delete snmp host 10.0.0.1
Command: delete snmp host 10.0.0.1
Success.
DES-3200-28P:admin#
63-15 show snmp host
Description
This command is used to display the recipient for which the traps are targeted.
Format
show snmp host {<ipaddr>}
Parameters
host - (Optional) The IP address of the recipient for which the traps are targeted.
<ipaddr> - Enter the IP address used for the configuration here.
If no parameter specified, all SNMP hosts will be displayed.
Restrictions
None.
Example
To show SNMP host:
DES-3200-28P:admin#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name / SNMPv3 User Name
--------------- --------------- ---------------------------------
10.90.90.3 V3 noauthnopriv initial
10.90.90.2 V2c private
10.90.90.1 V1 public
10.90.90.4 V3 authnopriv user123
10.90.90.5 V3 authpriv user234
Total Entries : 5
DES-3200-28P:admin#
63-16 config snmp engineID
Description
This command is used to configure a identifier for the SNMP engine on the Switch.