D-Link X-STACK DES-3200 SERIES - Chapter 22 Digital Diagnostic Monitoring (DDM) Commands

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
216
Chapter 22 Digital Diagnostic
Monitoring (DDM)
Commands
config ddm [trap | log] [enable | disable]
config ddm ports [<portlist> | all ] [[temperature_threshold | voltage_threshold |
bias_current_threshold | tx_power_threshold | rx_power_threshold] {high_alarm <float> |
low_alarm <float> | high_warning <float> | low_warning <float>} | {state[enable|disable] |
shutdown [alarm | warning | none]}]
show ddm
show ddm ports {<portlist>} [status | configuration]
22-1 config ddm
Description
The command configures the DDM log and trap action when encountering an exceeding alarm or
warning thresholds event.
Format
config ddm [trap | log] [enable | disable]
Parameters
trap - Specify whether to send traps, when the operating parameter exceeds the corresponding
threshold. The DDM trap is disabled by default.
log - Specify whether to send a log, when the operating parameter exceeds the corresponding
threshold. The DDM log is enabled by default.
enable - Specify to enable the log or trap sending option.
disable - Specify to disable the log or trap sending option.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure DDM log state to enable:
DES-3200-28P:admin#config ddm log enable
Command: config ddm log enable
Success.
DES-3200-28P:admin#
To configure DDM trap state to enable: