D-Link X-STACK DES-3200 SERIES - Config Mac_Based_Access_Control_Local Mac <Macaddr> [Vlan <Vlan_Name 32> | Vlanid <Vlanid 1-4094> | Clear_Vlan]

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
382
Parameters
mac - Specify the MAC address that can pass local authentication.
<macaddr> - Enter the MAC address used here.
vlan - (Optional) Specify the target VLAN by using the VLAN name. When this host is authorized,
it will be assigned to this VLAN.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
vlanid - (Optional) Specify the target VLAN by using the VID. When this host is authorized, it will
be assigned to this VLAN if the target VLAN exists.
<vlanid 1-4094> - Enter the VLAN ID here. This value must be between 1 and 4094.
If no vlanid or vlan parameter is specified, not specify the target VLAN for this host.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create one MAC-based Access Control local database entry for MAC address 00-00-00-00-00-
01 and specify that the host will be assigned to the “default” VLAN after the host has been
authorized:
DES-3200-28P:admin#create mac_based_access_control_local mac 00-00-00-00-00-01
vlan default
Command: create mac_based_access_control_local mac 00-00-00-00-00-01 vlan
default
Success.
DES-3200-28P:admin#
40-11 config mac_based_access_control_local
Description
This command is used to configure a MAC-based Access Control local database entry.
Format
config mac_based_access_control_local mac <macaddr> [vlan <vlan_name 32> | vlanid
<vlanid 1-4094> | clear_vlan]
Parameters
mac - Specify the authenticated host’s MAC address.
<macaddr> - Enter the MAC address used here.
vlan - Specify the target VLAN by VLAN name. When this host is authorized, the host will be
assigned to this VLAN.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
vlanid - Specify the target VLAN by VID. When this host is authorized, the host will be assigned
to this VLAN if the target VLAN exists.
<vlanid 1-4094> - Enter the VLAN ID here. This value must be between 1 and 4094.
clear_vlan - Not specify the target VLAN. When this host is authorized, will not assign target
VLAN.