D-Link X-STACK DES-3200 SERIES - Chapter 26 Filter Command List

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
237
Chapter 26 Filter Command List
config filter netbios [<portlist> | all] state [enable | disable]
show filter netbios
config filter extensive_netbios [<portlist> | all] state [enable | disable]
show filter extensive_netbios
26-1 config filter netbios
Description
This command is used to configure the Switch to deny the NETBIOS packets on specific ports.
Format
config filter netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Specify the list of ports used.
all - Specify that all the ports will be used for the configuration.
state- Specify the state of the filter to block the NETBIOS packet.
enable - Specify that the state will be enabled.
disable - Specify that the state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure filter netbios state:
DES-3200-28P:admin#config filter netbios 1-10 state enable
Command: config filter netbios 1-10 state enable
Success.
DES-3200-28P:admin#
26-2 show filter netbios
Description
This command is used to display the NETBIOS filter state on the Switch.
Format
show filter netbios