D-Link X-STACK DES-3200 SERIES - Page 242

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
238
Parameters
None.
Restrictions
None.
Example
To display the filter netbios list created on the Switch:
DES-3200-28P:admin#show filter netbios
Command: show filter netbios
Enabled ports: 1-3
DES-3200-28P:admin#
26-3 config filter extensive_netbios
Description
This command is used to configure the Switch to filter NETBIOS packets over 802.3 flame on the
specific ports.
Format
config filter extensive_netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of ports used for this configuration here.
all - Specify that all the ports will be used this configuration.
state - Enable or disable the filter to block the NETBIOS packet over 802.3 frame.
enable - Specify that the filter state will be enabled.
disable - Specify that the filter state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure filter extensive netbios state.
DES-3200-28P:admin#config filter extensive_netbios 1-10 state enable
Command: config filter extensive_netbios 1-10 state enable
Success.
DES-3200-28P:admin#