D-Link X-STACK DES-3200 SERIES - Page 176

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
172
15 0 0 0 0 0 0
16 0 0 0 0 0 0
17 0 0 0 0 0 0
18 0 0 0 0 0 0
19 0 0 0 0 0 0
20 0 0 0 0 0 0
21 0 0 0 0 0 0
22 0 0 0 0 0 0
23 0 0 0 0 0 0
24 0 0 0 0 0 0
25 0 0 0 0 0 0
26 0 0 0 0 0 0
27 0 0 0 0 0 0
28 0 0 0 0 0 0
DES-3200-28P:admin#show cfm pkt_cnt ccm
Command: show cfm pkt_cnt ccm
CCM RX counters:
XCON = Cross-connect CCMs
Error = Error CCMs
Normal = Normal CCMs
MEP Name VID Port Level Direction XCON Error Normal
----------- ---- ----- ------ ---------- ---------- ---------- ----------
1 1 1 1 Inward 0 0 0
28mep 45 3 7 Inward 0 0 2438
-------------------------------------------
Total: 0 0 2438
DES-3200-28P:admin#
16-26 clear cfm pkt_cnt
Description
This command is used to clear the CFM packet’s RX/TX counters.
Format
clear cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) The ports which require need the counters clearing. If not specified, all ports
will be cleared.
<portlist> - Enter the list of ports used for this configuration here.
rx - (Optional) Specify to clear the RX counter.
tx - (Optional) Specify to clear the TX counter. If not specified, both of them will be cleared.
rx - (Optional) Specify to clear the RX counter.
tx - (Optional) Specify to clear the TX counter. If not specified, both of them will be cleared.
ccm - (Optional) Specify the CCM RX counters.