D-Link X-STACK DES-3200 SERIES - Page 195

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
191
19-2 config dhcp_local_relay vlan vlanid
Description
This command is used to enable or disable DHCP local relay function for specified VLAN ID.
Format
config dhcp_local_relay vlan vlanid <vlan_id> state [enable | disable]
Parameters
vlanid - Specify the VLAN ID that the DHCP local relay function will be enabled.
<vlan_id> - Enter the VLAN ID used here.
state - Enable or disable DHCP local relay for specified vlan.
enable - Specify that the DHCP local relay function will be enabled.
disable - Specify that the DHCP local relay function will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable DHCP local relay for default VLAN:
DES-3200-28P:admin#config dhcp_local_relay vlan vlanid 1 state enable
Command: config dhcp_local_relay vlan vlanid 1 state enable
Success.
DES-3200-28P:admin#
19-3 config dhcp_local_relay option_82 circuit_id
Description
This command is used to configure the circuit id of DHCP relay agent information option 82 of the
switch.
Format
config dhcp_local_relay option_82 circuit_id [default | vendor1]
Parameters
default – Specify the cirecuit id of DHCP relay agent to default.
vendor1 - Specify the cirecuit id of DHCP relay agent to vendor1.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.