D-Link X-STACK DES-3200 SERIES - Page 197

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
193
Parameters
default - Use the Switch’s system MAC address as the remote ID.
user_define - Use user-defined string as the remote ID.
<desc 32> - Enter the maximum of 32 characters. Space is allowed in the string.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the remote ID:
DES-3200-28P:admin#config dhcp_local_relay option_82 remote_id user_define D-Lin
k L2Switch
Command: config dhcp_local_relay option_82 remote_id user_define D-Link L2Switch
Success.
DES-3200-28P:admin#
19-6 enable dhcp_local_relay
Description
This command is used to globally enable the DHCP local relay function on the Switch.
Format
enable dhcp_local_relay
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the DHCP local relay function:
DES-3200-28P:admin#enable dhcp_local_relay
Command: enable dhcp_local_relay
Success.
DES-3200-28P:admin#