D-Link X-STACK DES-3200 SERIES - Page 20

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
16
Format
config greeting_message {default}
Parameters
default - (Optional) Adding this parameter to the “config greeting_message” command will return
the greeting message (banner) to its original factory default entry.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To edit the banner:
DES-3200-28P:admin#config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
DES-3200-28P Fast Ethernet Switch
Command Line Interface
Firmware: Build 4.03.004
Copyright(C) 2012 D-Link Corporation. All rights reserved.
================================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
--------------------------------------------------------------------------------
2-13 show greeting_message
Description
The command is used to display greeting message.
Format
show greeting_message
Parameters
None.