D-Link X-STACK DES-3200 SERIES - Page 203

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
199
20-4 config dhcp_relay delete
Description
This command is used to delete one of the IP destination addresses in the Switch’s relay table.
Format
config dhcp_relay delete ipif <ipif_name 12> <ipaddr>
Parameters
ipif - The name of the IP interface which contains the IP address below.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
<ipaddr> - The DHCP/BOOTP server IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a DHCP/BOOTP server to the relay table:
DES-3200-28P:admin#config dhcp_relay delete ipif System 10.43.21.12
Command: config dhcp_relay delete ipif System 10.43.21.12
Success.
DES-3200-28P:admin#
20-5 config dhcp_relay delete vlanid
Description
This command is used to delete an IP address as a destination to forward (relay) DHCP/BOOTP
packets.
Format
config dhcp_relay delete vlanid <vlan_id_list> <ipaddr>
Parameters
vlanid - Specify the VLAN ID list used for this configuration.
<vlan_id_list> - Enter the VLAN ID list used for this configuration here.
<ipaddr> - Enter the DHCP/BOOTP server IP address used here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.