D-Link X-STACK DES-3200 SERIES - Page 227

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
223
DES-3200-28P:admin#config duld ports 1 state enable
Command: config duld ports 1 state enable
Success.
DES-3200-28P:admin#
23-2 show duld ports
Description
This command is used to show unidirectional link detection information.
Format
show duld ports {<portlist>}
Parameters
<portlist> - (Optional) Specify a range of ports.
Restrictions
None.
Example
To show ports 1-4 unidirectional link detection information:
DES-3200-28P:admin#show duld ports 1-4
Command: show duld ports 1-4
Port Admin State Oper Status Mode Link Status Discovery Time(Sec)
----- ----------- ----------- -------- -------------- -------------------
1 Enabled Disabled Normal Unknown 5
2 Disabled Disabled Normal Unknown 5
3 Disabled Disabled Normal Unknown 5
4 Disabled Disabled Normal Unknown 5
DES-3200-28P:admin#