D-Link X-STACK DES-3200 SERIES - Page 233

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
229
DES-3200-28P:admin#enable erps
Command: enable erps
Success.
DES-3200-28P:admin#
25-2 disable erps
Description
This command is used to disable the global ERPS function on a switch.
Format
disable erps
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable ERPS:
DES-3200-28P:admin#disable erps
Command: disable erps
Success.
DES-3200-28P:admin#
25-3 create erps raps_vlan
Description
This command is used to create an R-APS VLAN on a switch. Only one R-APS VLAN should be
used to transfer R-APS messages.
Note that the R-APS VLAN must already have been created by the create vlan command.
Format
create erps raps_vlan <vlanid>
Parameters
raps_vlan - Specify the VLAN which will be the R-APS VLAN.