D-Link X-STACK DES-3200 SERIES - Page 265

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
261
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To show the global GratuitousARP state:
DES-3200-28P:admin#config gratuitous_arp learning enable
Command: config gratuitous_arp learning enable
Success.
DES-3200-28P:admin#
29-4 config gratuitous_arp send periodically
Description
The command is used to configure the interval for periodical sending of gratuitous ARP request
packet. By default, the interval is 0.
Format
config gratuitous_arp send periodically ipif <ipif_name 12> interval <value 0-65535>
Parameters
ipif - Interface name of L3 interface.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
interval - Periodically send gratuitous ARP interval time in seconds. 0 means not send gratuitous
ARP periodically.
<value 0-65535> - Enter the gratuitous ARP interval time here. This value must be between 0
and 65535 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure gratuitous ARP interval to 5 for IPIF System:
DES-3200-28P:admin#config gratuitous_arp send periodically ipif System interval
5
Command: config gratuitous_arp send periodically ipif System interval 5
Success.
DES-3200-28P:admin#