EasyManua.ls Logo

D-Link X-STACK DES-3200 SERIES - Page 271

D-Link X-STACK DES-3200 SERIES
647 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
267
Parameters
vlan_name - Specify the name of the VLAN for which IGMP snooping is to be configured.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the VLAN ID for which IGMP snooping is to be configured.
<vlanid_list> - Enter the VLAN ID here.
all - Specify to use all configured VLANs.
state - (Optional) Enable or disable IGMP snooping for the chosen VLAN.
enable - Enter enable to enable IGMP snooping for the chosen VLAN.
disable - Enter disable to disable IGMP snooping for the chosen VLAN.
fast_leave - Enable or disable the IGMP snooping fast leave function.
enable - Enter enable to enable the IGMP snooping fast leave function. If enabled, the
membership is immediately removed when the system receives the IGMP leave message.
disable - Enter disable to disable the IGMP snooping fast leave function.
report_suppression - Specify IGMP report suppression. When enabled, multiple IGMP reports
or leave for a specific (S, G) will be integrated into one report only before sending to the router
port.
enable - Enable the IGMP report suppression.
disable - Disable the IGMP report suppression.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure IGMP snooping:
DES-3200-28P:admin#config igmp_snooping vlan_name default state enable
Command: config igmp_snooping vlan_name default state enable
Success.
DES-3200-28P:admin#
30-2 config igmp_snooping rate_limit
Description
This command is used to configure the rate of IGMP control packet that is allowed per port or per
VLAN.
Format
config igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports - Specify a range of ports to be configured.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list here.

Table of Contents

Related product manuals