D-Link X-STACK DES-3200 SERIES - Page 292

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
288
30-22 show igmp access_authentication ports
Description
This command is used to display the current IGMP Access Control configuration.
Format
show igmp access_authentication ports [all | <portlist>]
Parameters
all - Specify all ports to be displayed.
<portlist> - Specify a range of ports to be displayed.
Restrictions
None.
Example
To display the IGMP Access Control status for ports 1-4:
DES-3200-28P:admin#show igmp access_authentication ports 1-4
Command: show igmp access_authentication ports 1-4
Port State
----- ---------
1 Enabled
2 Disabled
3 Disabled
4 Disabled
DES-3200-28P:admin#
To display the IGMP Access Control status for all ports:
DES-3200-28P:admin#show igmp access_authentication ports all
Command: show igmp access_authentication ports all
Port State
----- ---------
1 Enabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
6 Disabled
7 Disabled
8 Disabled
9 Disabled
10 Disabled
11 Disabled