D-Link X-STACK DES-3200 SERIES - Page 30

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
26
Parameters
<vidlist> - Enter a list of VLAN IDs to configure.
add - (Optional) Specify to add tagged, untagged or forbidden ports to the VLAN.
tagged - Specify the additional ports as tagged.
untagged - Specify the additional ports as untagged.
forbidden - Specify the additional ports as forbidden.
delete - (Optional) Specify to delete ports from the VLAN.
<portlist> - (Optional) Enter the list of ports used for the configuration here.
advertisement - (Optional) Specify the GVRP state of this VLAN.
enable - Specify to enable advertisement for this VLAN.
disable - Specify to disable advertisement for this VLAN.
name - (Optional) The new name of the VLAN.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add 4 through 8 as tagged ports to the VLAN ID from 10-20:
DES-3200-28P:admin#config vlan vlanid 10-20 add tagged 4-8
Command: config vlan vlanid 10-20 add tagged 4-8
Success.
DES-3200-28P:admin#
3-7 config port_vlan
Description
This command is used to set the ingress checking status, the sending and receiving GVRP
information.
Format
config port_vlan [<portlist> | all] {gvrp_state [enable | disable] | ingress_checking [enable |
disable] | acceptable_frame [tagged_only | admit_all] | pvid <vlanid 1-4094>}(1)
Parameters
<portlist> - A range of ports for which you want ingress checking. The port list is specified by
listing the beginning port number on the Switch, separated by a colon. Then highest port
number of the range (also separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash.
all - Specify all ports for ingress checking.
gvrp_state - (Optional) Enabled or disables GVRP for the ports specified in the port list.
enable - Specify that GVRP for the specified ports will be enabled.
disable - Specify that GVRP for the specified ports will be disabled.
ingress_checking - (Optional) Enables or disables ingress checking for the specified portlist.
enable - Specify that ingress checking will be enabled for the specified portlist.
disable - Specify that ingress checking will be disabled for the specified portlist.