D-Link X-STACK DES-3200 SERIES - Page 311

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
307
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear MLD snooping statistics counter:
DES-3200-28P:admin#clear mld_snooping statistics counter
Command: clear mld_snooping statistics counter
Success.
DES-3200-28P:admin#
30-43 config mld_snooping rate_limit
Description
This command is used to configure the rate limit of MLD control packets that are allowed by each
port or VLAN.
Format
config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports - Specify a range of ports to be configured.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list here.
<value 1-1000> - Configure the rate limit of MLD control packets that the Switch can process on
a specific port or VLAN. The rate is specified in packet per second. The packets that exceed
the limited rate will be dropped.
no_limit - Configure the rate limit of MLD control packets that the Switch can process on a
specific port or VLAN. The rate is specified in packet per second. The packets that exceed the
limited rate will be dropped. The default setting is no_limit.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MLD snooping per port rate limit: