D-Link X-STACK DES-3200 SERIES - Page 343

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
339
36-2 delete link_aggregation group_id
Description
This command is used to delete a previously configured link aggregation group.
Format
delete link_aggregation group_id <value>
Parameters
group_id - Specify the group id. The number of link aggregation groups is project dependency.
The group number identifies each of the groups.
<value> - Enter the group ID value here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete link aggregation group:
DES-3200-28P:admin#delete link_aggregation group_id 3
Command: delete link_aggregation group_id 3
Success.
DES-3200-28P:admin#
36-3 config link_aggregation group_id
Description
This command is used to configure a previously created link aggregation group.
Format
config link_aggregation group_id <value> {master_port <port> | ports <portlist> | state
[enable | disable]
Parameters
group_id - Specify the group id. The group number identifies each of the groups.
<value> - Enter the group ID value here. This value must be between 1 and 32.
master_port - (Optional) Master port ID. Specify which port (by port number) of the link
aggregation group will be the master port. All of the ports in a link aggregation group will share
the port configuration with the master port.
<port> - Enter the master port number here.
ports - (Optional) Specify a range of ports that will belong to the link aggregation group.
<portlist> - Enter the list of port used for the configuration here.
state - (Optional) Enable or disable the specified link aggregation group. If not specified, the
group will keep the previous state, the default state is disabled. If configure LACP group, the