D-Link X-STACK DES-3200 SERIES - Page 346

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
342
DES-3200-28P:admin#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-Source-Dest
Group ID : 1
Type : LACP
Master Port : 5
Member Port : 5-7
Active Port :
Status : Enabled
Flooding Port :
Total Entries : 1
DES-3200-28P:admin#
Link aggregation group disabled:
DES-3200-28P:admin#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-Source-Dest
Group ID : 1
Type : LACP
Master Port : 5
Member Port : 5-7
Active Port :
Status : Disabled
Flooding Port : 7
Total Entries : 1
DES-3200-28P:admin#
36-6 config lacp_port
Description
This command is used to configure per-port LACP mode.
Format
config lacp_port <portlist> mode [active | passive]
Parameters
lacp_port - Specify a range of ports to be configured.
<portlist> - Enter the list of port used for the configuration here.
mode - Specify the LACP mode used.
active - Specify to set the LACP mode as active.