D-Link X-STACK DES-3200 SERIES - Page 372

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
368
Example
To specify that traps will be sent when the loop condition is detected or cleared:
DES-3200-28P:admin#config loopdetect trap both
Command: config loopdetect trap both
Success.
DES-3200-28P:admin#
38-8 config loopdetect log
Description
This command is used to configure the log state for LBD. The default value is enabled.
Format
config loopdetect log state [enable | disable]
Parameters
state - Specify the state of the LBD log feature.
enable - Enable the LBD log feature.
disable - Disable the LBD log feature. All LBD-related logs will not be recorded.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the log state for LBD:
DES-3200-28P:admin#config loopdetect log state enable
Command: config loopdetect log state enable
Success.
DES-3200-28P:admin#