D-Link X-STACK DES-3200 SERIES - Page 405

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
401
DES-3200-28P:admin#debug stp clear counter ports all
Command: debug stp clear counter ports all
Success.
DES-3200-28P:admin#
43-6 debug stp state
Description
This command is used to enable or disable the STP debug state.
Format
debug stp state [enable | disable]
Parameters
state - Specify the STP debug state.
enable - Enable the STP debug state.
disable - Disable the STP debug state.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the STP debug state to enable, and then disable the STP debug state:
DES-3200-28P:admin#debug stp state enable
Command: debug stp state enable
Success.
DES-3200-28P:admin#debug stp state disable
Command: debug stp state disable
Success.
DES-3200-28P:admin#