D-Link X-STACK DES-3200 SERIES - Page 408

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
404
Format
config mcast_filter_profile ipv6 [profile_id <value 1-24> | profile_name <name 1-32> ]
{profile_name <name 1-32> | [add | delete] <mcastv6_address_list>}(1)
Parameters
profile_id - ID of the profile.
<value 1-24> - Enter the profile ID value here. This value must be between 1 and 24.
profile_name - Provides a meaningful description for the profile.
<name 1-32> - Enter the profile name here. The profile name can be up to 32 characters long.
profile_name - (Optional) Provides a meaningful description for the profile.
<name 1-32> - Enter the profile name here. The profile name can be up to 32 characters long.
add - (Optional) Specify to add an IPv6 multicast address.
delete - (Optional) Specify to delete an IPv6 multicast address.
<mcastv6_address_list> - (Optional) Lists the IPv6 multicast addresses to put in the profile. You
can either specify a single IPv6 multicast IP address or a range of IPv6 multicast addresses
connected by ‘-‘.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add the IPv6 multicast address range FFF0E::100:0:0:20 – FFF0E::100:0:0:22 to profile ID 3:
DES-3200-28P:admin#config mcast_filter_profile ipv6 profile_id 3 add
FF0E::100:0:0:20– FFF0E::100:0:0:22
Command: config mcast_filter_profile ipv6 profile_id 3 add FF0E::100:0:0:20–
FFF0E::100:0:0:22
Success.
DES-3200-28P:admin#
44-4 delete mcast_filter_profile
Description
This command is used to delete a multicast address profile. If the IPv4 or IPv6 option is not
specified, IPv4 is implied.
Format
delete mcast_filter_profile {[ipv4 | ipv6]} [profile_id [<value 1-24> | all] | profile_name <name
1-32>]
Parameters
ipv4 - (Optional) Specify to delete an IPv4 multicast profile.
ipv6 - (Optional) Specify to delete an IPv6 multicast profile.
profile_id - Specify the ID of the profile