D-Link X-STACK DES-3200 SERIES - Page 420

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
416
to 32 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an IGMP snooping multicast group profile with the name “test”:
DES-3200-28P:admin#create igmp_snooping multicast_vlan_group_profile test
Command: create igmp_snooping multicast_vlan_group_profile test
Success.
DES-3200-28P:admin#
45-4 config igmp_snooping multicast_vlan_group_profile
Description
This command is used to configure an IGMP snooping multicast group profile on the Switch and
add or delete multicast addresses for the profile.
Format
config igmp_snooping multicast_vlan_group_profile <profile_name 1-32> [add | delete]
<mcast_address_list>
Parameters
multicast_vlan_group_profile - Specify the multicast VLAN profile name. The maximum length
is 32 characters.
<profile_name 1-32> - Enter the multicast VLAN group name here. This name can be up to
32 characters long.
add - Adds a multicast address list to or from this multicast VLAN profile. The
<mcast_address_list> can be a continuous single multicast address, such as 225.1.1.1,
225.1.1.3, 225.1.1.8, a multicast address range, such as 225.1.1.1-225.2.2.2, or both of types,
such as 225.1.1.1, 225.1.1.18-225.1.1.20.
delete - Deletes a multicast address list to or from this multicast VLAN profile. The
<mcast_address_list> can be a continuous single multicast addresses, such as 225.1.1.1,
225.1.1.3, 225.1.1.8, or a multicast address range, such as 225.1.1.1-225.2.2.2, or both types,
such as 225.1.1.1, 225.1.1.18-225.1.1.20.
<mcast_address_list> - Enter the multicast VLAN IP address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add the single multicast address 225.1.1.1 to the IGMP snooping multicast VLAN profile named
“test”: