D-Link X-STACK DES-3200 SERIES - Page 461

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
457
Format
show environment
Parameters
None.
Restrictions
None.
Example
To display the device environment:
DES-3200-28P:admin#show environment
Command: show environment
Temperature Trap State : Enabled
Temperature Log State : Enabled
Internal Power : Active
External Power : None
Current Temperature(Celsius) : 32
High Warning Temperature Threshold(Celsius) : 79
Low Warning Temperature Threshold(Celsius) : 11
DES-3200-28P:admin#
50-3 config temperature threshold
Description
This command is used to configure the warning threshold for high and low temperature.
Format
config temperature threshold {high <temperature -500-500> | low <temperature -500-500>}
Parameters
threshold - Specify the high and low threshold value.
high - (Optional) To configure high threshold value. The high threshold must bigger than the
low threshold.
<temperature -500-500> - Enter the high threshold temperature.
low - (Optional) To configure low threshold value.
<temperature -500-500> - Enter the low threshold temperature.
Restrictions
Only Administrator and Operator-level users can issue this command.