D-Link X-STACK DES-3200 SERIES - Page 511

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
507
57-18 show dscp map
Description
This command is used to show DSCP trusted port list and mapped color, priority and DSCP.
Format
show dscp map {<portlist>} [dscp_priority | dscp_dscp | dscp_color] {dscp <dscp_list>}
Parameters
<portlist> - (Optional) A range of ports to show. If no parameter is specified, all ports’ dscp
mapping will be displayed.
dscp_priotity - Specify a list of DSCP value to be mapped to a specific priority.
dscp_dscp - Specify a list of DSCP value to be mapped to a specific DSCP.
dscp_color - Specify a list of DSCP value to be mapped to a specific color.
dscp - (Optional) This specifies DSCP value that will be mapped.
<dscp_list> - Enter the DSCP list here.
Restrictions
None.
Example
In case of project support per port configure, show DSCP map configuration on port 1.
DES-3200-28P:admin#show dscp map 1 dscp_dscp
Command: show dscp map 1 dscp_dscp
DSCP to DSCP Mapping:
--------------------------------------------------------------
Port 1 | 0 1 2 3 4 5 6 7 8 9
-----------+--------------------------------------------------
0 | 0 1 2 3 4 5 6 7 8 9
1 | 10 11 12 13 14 15 16 17 18 19
2 | 20 21 22 23 24 25 26 27 28 29
3 | 30 31 32 33 34 35 36 37 38 39
4 | 40 41 42 43 44 45 46 47 48 49
5 | 50 51 52 53 54 55 56 57 58 59
6 | 60 61 62 63
--------------------------------------------------------------
DES-3200-28P:admin#