D-Link X-STACK DES-3200 SERIES - Page 590

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
586
Parameters
firmware_fromTFTP – Specify to download firmware from a TFTP server.
<ipaddr> - (Optional) The IP address of the TFTP server.
src_file - (Optional) Used to identify the parameter “path_filename”.
<path_filename 64> - Enter the source file path name here. This name can be up to 64
characters long.
dest_file - (Optional) Used to identify the parameter “path_filename”.
<pathname 64> - Enter the destination file path name here.
boot_up – (Optional) Assign the downloaded file as boot-up image.
cfg_fromTFTP – Specify to download a configuration file from a TFTP server.
<ipaddr> - (Optional) The IP address of the TFTP server.
src_file - (Optional) Used to identify the parameter “path_filename”.
<path_filename 64> - The pathname specifies the pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This name can be up to 64 characters
long.
dest_file - (Optional) Used to identify the parameter “path_filename”.
<pathname 64>- The pathname specifies an absolute pathname on the device file system.
If pathname is not specified, it refers to the boot_up configuration file.
firmware_fromFTP – Specify to download firmware from a FTP server.
<ipaddr> - (Optional) The IP address of the FTP server.
tcp_port - Specify the TCP port.
<tcp_port_number1-65535> - Enter a value between 1 and 65535.
src_file - Specify the source file location.
<path_filename 64> - The pathname specifies the pathname on the FTP server. It can be
a relative pathname or an absolute pathname. This name can be up to 64 characters
long.
ftp: - Specify the FTP site.
<string user:password@ipaddr:tcpport/path_filename> - Enter the FTP directory.
dest_file – Used to identify the parameter “path_filename”.
<path_filename 64> - The pathname specifies an absolute pathname on the device file
system. If pathname is not specified, it refers to the boot_up configuration file.
boot_up - (Optional) Assign the downloaded file as boot-up image.
cfg_fromFTP – Specify to download a configuration file from a FTP server.
<ipaddr> - The IP address of the FTP server.
tcp_port - (Optional) Specify the TCP port.
<tcp_port number 1-65535> - Enter a value between 1 and 65535.
src_file - Used to identify the parameter “path_filename”.
<path_filename 64> - The pathname specifies the pathname on the FTP server. It can be
a relative pathname or an absolute pathname. This name can be up to 64 characters
long.
ftp: - Specify the FTP site.
<string user:password@ipaddr:tcpport/path_filename> - Enter the FTP directory.
dest_file – Used to identify the parameter “path_filename”.
<path_filename 64> - The pathname specifies an absolute pathname on the device file
system. If pathname is not specified, it refers to the boot_up configuration file.
Restrictions
Only Administrator-level users can issue this command.
Example
To download firmware from TFTP: