D-Link X-STACK DES-3200 SERIES - Page 611

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
607
Example
To enable both the occurred mode and cleared mode traffic control traps:
DES-3200-28P:admin#config traffic trap both
Command: config traffic trap both
Success.
DES-3200-28P:admin#
72-3 show traffic control
Description
This command is used to display the current traffic control settings.
Format
show traffic control {<portlist>}
Parameters
<portlist> - (Optional) Used to specify the range of ports to be shown.
If no parameter is specified, the system will display the packet storm control configuration for all
ports.
Restrictions
None.
Example
To display the traffic control parameters for ports 1 to 10: